Cem Dual Mig 120 Manual -

Terminal studs or push-on links inside the wire drive compartment used to change polarity between MIG (Gas) and MAG/Flux-Cored (Gasless). Setup Guide: Gas vs. Gasless Modes

0.6mm – 0.8mm solid wire (Gas); 0.8mm – 0.9mm flux-cored wire (Gasless). Welding Capacity: Mild steel up to 4mm–5mm thickness. Protection Rating: IP21 or IP23 (standard for workshop use). clarkeservice.co.uk Key Controls and Setup Polarity Selection: MIG (Gas): Torch is positive (+), Ground clamp is negative (-). Gasless (Flux-Cored): Torch is negative (-), Ground clamp is positive (+). Wire Installation: cem dual mig 120 manual

Low Voltage (Min-1), High Wire Speed (approx. 3-4) Terminal studs or push-on links inside the wire

Place the wire spool onto the spindle. Adjust the plastic retaining nut so the spool spins smoothly but does not unravel freely when stopped. Welding Capacity: Mild steel up to 4mm–5mm thickness

Heavy-duty 3-core cable with grounded plug.

is designed for portability and ease of use, typically operating on a standard household 120V circuit. Its primary advantage is its flexibility:

This potentiometer controls how fast the motor pushes the wire. This must be tuned by ear—you’re looking for a consistent "sizzling bacon" sound.