Simrad Rf300 Installation Manual Jun 2026

: Attach the ball joint to the rudder tiller arm. Connect the transmitter rod to this ball joint.

Once installed, the unit must be configured through your Simrad Control Unit or Multifunction Display (MFD). B&G RF300 Rudder Feedback Unit - Simrad Commercial simrad rf300 installation manual

This paper provides a comprehensive technical guide for the installation, configuration, and maintenance of the Simrad RF300 Rudder Feedback Unit. As a critical component in modern autopilot systems, the RF300 provides essential data regarding rudder position, enabling accurate course-keeping and maneuverability. This document outlines the necessary tools, mounting procedures, electrical interfacing, and calibration steps required to ensure optimal performance. Special attention is given to mechanical alignment and compatibility with Simrad autopilot computers. : Attach the ball joint to the rudder tiller arm

Manually move the rudder from hard-over to hard-over to ensure the linkage operates smoothly without binding or reaching its mechanical limit. B&G RF300 Rudder Feedback Unit - Simrad Commercial

Locate a flat, rigid structural member or bulkhead near the rudder quadrant or tiller arm. Place the RF300 unit on the mounting surface.

Once installed, the unit needs to be recognized by the Simrad Autopilot system. Turn on your Simrad Autopilot system. Navigate to the menu. Select Rudder Feedback Calibration .

Follow the on-screen wizard to turn the wheel hard-over to port, then hard-over to starboard. This sets the maximum rudder angles and centers the steering. Quick Maintenance Tips B&G RF300 Rudder Feedback Unit | Autopilot - Simrad